R100 gearbox

How to; Why did it do that?; What do I do now!...
Post Reply
goodguy
Posts: 410
Joined: Wed 18 Apr, 2012 10:25 am
Junk Test: No
Enter the middle number (7726): 7726

R100 gearbox

Post by goodguy »

At the last tuning day John W & Nev had a listen to my R100 clutch gearbox noise, consensus was likely worn thrust bearing. Today pulled out the gearbox, stuck to the magnetic drain plug was about a centimeter long piece of looks like tooth.
Q..John, Nev..could that noise have been gearbox noise only (of course will replace the thrust bearing)... I guess my only option is to send it east to Ray Peake ?
bowewilson@gmail.com
Posts: 224
Joined: Mon 15 Nov, 2010 8:52 am
Junk Test: No
Enter the middle number (7726): 7726

Re: R100 gearbox

Post by bowewilson@gmail.com »

Guy
Highly likely you have found the only problem, seemed to be where the noise was coming from, you would be unlucky for a diff or motor to go at the same time, Thorsten might be able to fix for you.
Bowe
spacey1
Posts: 1020
Joined: Tue 10 Aug, 2010 8:08 pm
Junk Test: No
Enter the middle number (7726): 7726

Re: R100 gearbox

Post by spacey1 »

Good to hear you've identified the problem.

Lucky that magnet picked up the broken tooth! That could have been a ripper failure... No more wheelies and burnouts for you...

DO remove and inspect your clutch, flywheel and ring gear... Don't forget to block the front of the crank to stop it falling out... And mark the flywheel position to ensure the timing mark goes back in the right place.

I don't recall being any part of that conversation other than saying that it didn't matter what the noise was, the gearbox had to come off... :|
Himalayas Royal Enfield Tour 2017; Camp Cook-Off Winner 2017; Kennedy Ranges; Three Oceans Tour Australia; Hyden-Norseman Breakaways; R1200 series final drive repair; Mt Augustus; Bimbijy Station; Around Oz
goodguy
Posts: 410
Joined: Wed 18 Apr, 2012 10:25 am
Junk Test: No
Enter the middle number (7726): 7726

Re: R100 gearbox

Post by goodguy »

Thanks Bowe, Nev...will get in touch with Thorsten.
Post Reply