Club Tool Recovered: 30mm Deep socket / 12mm Allen key
Posted: Tue 14 Jan, 2020 2:14 pm
This Socket and Allen Key tool set for torquing the R1200 series swing arm bearing was borrowed and not returned.
If you know where it is, please let me know... or perhaps return it...

HRGriceness was good enough to machine the side of a 30mm deep socket and cutting down a 12mm allen key.
This is to torque the swing-arm bearings and lock-nut appropriately
If you know where it is, please let me know... or perhaps return it...

HRGriceness was good enough to machine the side of a 30mm deep socket and cutting down a 12mm allen key.
This is to torque the swing-arm bearings and lock-nut appropriately
